TM1637 4 Digit Display

This node lets you use any 4 digit display that uses the TM1637 LED Driver library.

Setup is easy, simply connect the vcc pin to the Arduino's output voltage pin, the GND pin to the Arduino's ground pin, then the CLK and DIO pins to any digital pins. Add this node to an agent then just set the CLK and DIO inputs to match your hardware setup, then after connecting to your Arduino you can update the display by changing the value and brightness inputs.

Supported Products

View discussion page on forum

To use this node in your Embrio project, either add it from the Library toolbar or copy the XML in the below box and paste it into a node screen.